Electrician Priority Toronto · Leaside

Pot light installation in Leaside and Midtown

Slim LED pot lights for open-concept main floors, underpinned basements, kitchens and exterior soffits, laid out properly and on dimmers that actually dim.

Lighting renovated Midtown homes

A typical Leaside or Davisville renovation takes out a wall or two, opens the kitchen to the living room and underpins the basement for more height. The original ceiling fixtures don’t suit the new layout, and a single light per room leaves an open-concept floor patchy and dim. Recessed lighting ties the space together, as long as it is planned around the furniture, the kitchen and the way the rooms flow into each other.

In older Moore Park and North Rosedale houses with plaster ceilings and decorative mouldings, we keep cuts away from the details worth preserving and support the plaster as we work.

How we lay them out

  • Open-concept main floors: separate zones for kitchen, dining and living, each on its own dimmer, so you can light one area without the others.
  • Kitchens: lights aligned over the counter edge and the island, plus under-cabinet lighting for task work.
  • Underpinned basements: slim fixtures that fit around ductwork and bulkheads, spaced for an even light across the whole floor.
  • Vaulted and sloped ceilings: fixtures with adjustable trims so the light points down rather than at the wall.
  • Exteriors: soffit lights and landscape lighting to show off the house and light the walk.

The details that make the difference

We use slim LED wafer fixtures that need very little ceiling depth and no separate housing, so cuts are small and clean. Where a light sits under an attic or a roof, it is IC-rated and airtight to stop heat loss. Each zone gets an LED-rated dimmer matched to the fixtures, so the lights dim smoothly without flicker. You choose the colour temperature, warm 2700K to 3000K for living areas or crisper 3500K to 4000K for kitchens and workspaces, and colour-selectable fixtures let you decide once you see them in the room. Every location is marked and agreed on with you before we cut anything.

How a pot light job works

  1. Photos and plans. Send photos of the space, or renovation drawings if you have them.
  2. Layout on site. We mark every light, switch and dimmer location with you before cutting.
  3. Install. Cut, fish, wire and mount. Most rooms are done in a day; during a renovation we rough in before drywall.
  4. Test and tidy. All zones and dimmers tested together, and dust cleaned up before we leave.

Pot light questions

Is it better to install pot lights during a renovation?

Yes, if you can. With the ceilings open, wiring is fast and there are no access holes to patch. We work with your contractor’s schedule to rough in before drywall.

How far apart should pot lights be?

It depends on ceiling height and the fixtures, but four to six feet apart is a common starting point. We lay out each room individually.

Can I control pot lights from my phone?

Yes. Smart dimmers work with most LED pot lights and can be set on schedules or controlled by voice.

Do you install landscape and soffit lighting?

Yes, including timers, photocells and smart controls.

Will pot lights work in a plaster ceiling?

Yes. Plaster takes more care than drywall, and we cut slowly to avoid cracking. Slim fixtures keep the openings small.

Can you replace my old halogen pot lights with LED?

Usually, yes, either with LED retrofit modules in the existing housings or by swapping in slim LED fixtures, which also cuts the heat they put into the ceiling.