Electrician Priority Toronto · Leaside

EV charger installation in Leaside and Midtown

Level 2 home chargers for garages and driveways across Leaside, Davisville and Moore Park, including two-car households that need both vehicles charged by morning.

Start with the panel

Every charger install starts with a look at the panel and a load calculation. A Level 2 charger typically needs a 40 to 60 amp circuit, and many Midtown houses are already carrying air conditioning, a big kitchen and a finished basement on a 100 or 125 amp service. Depending on what the numbers show, we either add a dedicated circuit, install an EV energy management system that slows or pauses charging when the house is busy, or plan the charger alongside a panel upgrade. We also look at where the panel sits relative to the parking spot, since the length and route of the run affect both the wire size and the work involved.

Two EVs, one panel

More and more households in Leaside and Moore Park have two electric cars, or one EV and a plug-in hybrid. Two full-power circuits are often more than the service can spare. Instead, chargers that support power sharing, like the Tesla Wall Connector, can split a single circuit between two cars and balance the current automatically, so both are charged overnight without upgrading the service. Load management devices can do a similar job for other brands. We look at your driving, your panel and your parking, and set it up so it simply works every night.

Garages, driveways and mutual drives

Leaside houses often have a detached garage at the end of a long driveway, while Davisville and Chaplin Estates have plenty of mutual drives and tight side yards. North Rosedale and Moore Park homes are more likely to have attached garages. Each changes the job:

  • Attached garage: usually a direct run from the panel.
  • Detached garage: a feed from the house, overhead or in buried conduit, sometimes with a small sub-panel.
  • Driveway: an outdoor-rated charger mounted on the house, placed so the cable reaches without crossing a path.

We install Tesla, ChargePoint, Grizzl-E, FLO and other major brands, hardwired for daily use, under an ESA permit and inspection.

How an EV charger install works

  1. Send photos. Your panel, where you park, and the car and charger you have or are considering.
  2. Capacity check. A load calculation decides between a direct circuit, power sharing, load management or an upgrade.
  3. Installation. Breaker, wiring and charger mounted and connected, usually in a single visit for an attached garage or driveway.
  4. Setup and test. We configure the charger’s current to match the circuit and test it with your car where possible.

EV charger questions

Can I install two chargers on one circuit?

With chargers that support power sharing, yes. They divide the available current between the cars automatically. It is often the most practical way to charge two EVs on a typical Midtown service.

What size circuit does my charger need?

Most home chargers run on a 40 to 60 amp circuit. The right size depends on the charger, the car’s onboard charger and how much capacity your panel has.

Do I need a permit?

Yes. EV charger installations in Ontario require an ESA permit and inspection, which is part of the job.

Can you put the charger outside?

Yes. We use outdoor-rated equipment and mount it on the house or a post near the driveway.

Will charging raise my hydro bill much?

It depends on how much you drive, but charging overnight on Toronto Hydro’s off-peak or ultra-low overnight rates keeps the cost down. Most chargers and cars let you schedule charging for those hours.

How long does an install take?

A charger in an attached garage or on a driveway near the panel is usually a single visit. Detached garages, power-sharing setups and panel upgrades take longer, and we tell you upfront.