Electrician Priority Toronto · Leaside

Electrical repairs in Leaside and Davisville

Breakers that will not reset, outlets that went dead, lights that flicker. We find the fault before we fix it, in Leaside houses old and new.

Old wiring, new additions

A lot of Leaside houses are a 1930s brick original with a newer addition on the back or a second storey on top. The new part is usually wired well. Trouble tends to show up where new circuits meet old ones, or where an older circuit was extended to reach the addition.

Repairs we do every week

  • A dead circuit after a renovation. Often a buried junction or a connection disturbed during the work. We track it down without opening more wall than needed.
  • GFCI outlets that trip or will not reset. Moisture in an exterior or bathroom outlet, or a fault further down the line.
  • A breaker that trips at the same time every day. That pattern points to one appliance, like a sump pump, freezer or space heater.
  • Flickering throughout the house. Can mean a loose neutral at the panel or service. We check it first.
  • Spliced or brittle wiring in a ceiling box. Common when old fixtures come down. We make it safe and tell you if the run should be replaced.

The visit

  1. Tell us the symptoms. What stopped, when, and anything that changed recently.
  2. Diagnose. Testing at the panel and at the device.
  3. Repair. Fixed, tested, and explained in plain terms.

If the fault is old wiring, see home rewiring or knob-and-tube replacement.

Repair FAQ

My GFCI will not reset. Is it broken?

Sometimes. It can also be refusing to reset because there is still a fault on the circuit. We test before replacing it.

Can you come for one small repair?

Yes. Small repairs are a normal part of what we do.

Why did a circuit die after my renovation?

A connection may have been disturbed or covered over. We trace it from both ends to find it.